WolverineSpartan Electronics Kit for V2 Gearboxes
Getting Started
The Spartan Electronics board combines a
trigger board and FCU into one powerful board.
Before you begin, please see the diagrams below
and familiarize yourself with each component.
Installation
The Spartan Electronics for AEG board is
designed to easily drop into a V2 gearbox. Separate the gearbox from the AEG and remove the
trigger spring and the small screw holding the
board in place.
Semi / Auto / Burst Switching
The Spartan Electronics board can be cycled
through five different fire modes as listed below.
To advance to the next fire mode, set your gun
to semi mode and hold the trigger. After 10 seconds, the board will advance to the next setting.
Fire modes
• Semi / Full Auto (Default in US)
• Semi / 3-Round Burst
• Semi / Semi (Default in UK
Rate of Fire Programming
1. Enter programming mode by unplugging the
battery, holding down the trigger and then plugging in the battery. The gun will now fire every
time the trigger is released, indicating you are in
programming mode.
2. Set the select-fire switch to full-auto to enter ROF programming mode.
3. Pressing and holding the trigger will produce
a 3-round burst once every second, gradually
increasing each time. Once the maximum setting
is reached, the board will cycle to the lowest setting and repeat the process. When the desired
ROF is reached, release the trigger.
4. Exit programming mode by disconnect the
battery.
Tuning / Dwell Programming
Before you start, you will want a loaded magazine, a filled tank with your regulator set to your
desired operating pressure. For best results, we
recommend using a chronograph.
1. Enter programming mode by unplugging the
battery, holding down the trigger and then plugging in the battery. The gun will now fire every
time the trigger is released, indicating you are in
programming mode.
2. Set the select-fire switch to semi-auto to
enter dwell programming mode.
3. Insert your loaded magazine and plug in the
air line.
4. With the gun pointed through the chronograph, press and hold down the trigger. The gun
will fire once per second, reducing the dwell with
each shot. Watch the chronograph and release
the trigger when you see a drop of about 10 fps.
If you do not have a chronograph simply watch
for the trajectory of the BB to drop indicating a
loss of velocity.
5. Double-tap the trigger to increase the dwell
to the previous setting.
Note: You may test fire by pressing and releasing the trigger to verify that setting is correct.
Double tapping the trigger will increase the
dwell further if necessary. If you hold the trigger
down long enough to cycle through all the dwell
settings the gun will shoot twice indicating that it
has cycled back to the highest dwell setting.
6. Exit programming mode by disconnect the
battery.
Need more help => www.wolverineairsoft.com